3 Flagpole Installation Choices;

  
Above Ground Mount
Installs in 2 minutes

(Purchased Seperately)
Click on Photo for more info.

Under Tire Mount
Just drive your vehicle on the mount. Great for showing pride at events. Our flagpoles just slide onto the mount
(Purchased Seperately)
Click on Photo for more info.

In Ground
 Comes with Kit.

Skroll down for more info.

 
Tools and Materials Needed:
- post hole digger or spade shovel
- level
- ruler or tape measure
- 1 40# bag of quick setting concrete
- 1/2 Gal. of gravel
- mixing container.
 
1. Select flag pole location. Check for underground sprinkler water lines and electrical lines before you dig.

2. Dig a 22'' hole with a tapered diameter, see diagram below.

3. Put 2'' of gravel under base of sleeve, (Allows for drainage) tamp stone.

4. Place aluminum sleeve (bead down) with bottom section of pole into place so cement won’t fill bottom of sleeve.

5. Mix bag of cement and pour into hole.

6. Mound up concrete around sleeve to allow for water runoff. (Add rocky fill to increase concrete volume).

7. Use level to square vertical. Stabilize for 24 hours. Insert remaining sections.

(Skroll down for more detailed drawings of both pole styles and for instructions on attaching clip(s) to halyard).
 

   
 
Back to order flagpoles page
Back to order military-veterans flagpole page